Linseed oil, filtered and cooked with traditional systems and with the addition of drying agents, without resins. It is ideal for the preparation of oil pigments. It gives a brilliant finish to both raw and stripped wood. Base oil and natural effect finish. It penetrates deeply into the porosity of the wood. Natural and bright effect. Also recommended as a sealant for terracotta and other surfaces before waxing. The treated surface will be soft and delicate, and will need to be restored periodically to maintain its natural beauty.

Natural oil, ideal for the preparation of oil-based pigments. It can be used as a primer and finish for natural-effect wood. It penetrates deeply into the porosity of the wood, giving the surface a bright look. It is necessary to periodically carry out maintenance to keep its beauty intact. For internal use only.

External wood basecoat, for grainy and brittle wooden surfaces. It masks inhomogeneity and restores a clear and luminous color. Sealing and consolidating, it prepares the surface for finishing, usually withHolzwachs lasur 3in1.

A wax-based brightener which is especially suited for reviving laminates, for everyday use against wear and tear. Water soluble, formaldehyde free, odorless.

Iron-micaceous enamel is a ready-to-use product, easy to apply, special for metal, indoors and outdoors, with exceptional anticorrosive and decorative properties. Creates a water-repellent and weather-resistant film, with a pleasantly antique look. Thanks to the special formulation with medium-fine grain micaceous iron oxides, it guarantees excellent coverage and long-term protection. Smooth and elastic, it is characterized by an excellent distension and does not drip. strong> p>

Fields of use:
It is recommended for the finishing or maintenance of iron surfaces, with or without the use of Anti-rust Undercoat (code 6915) or a high coverage Undercoat (code 6910).
It can also be applied on wood to obtain an effect similar to that of wrought iron.
Ideal for gates, railings, fixtures and metal elements in general. p>

A waterbased acrylic, waxy impregnating self-sealing 3-in-1 finish for interiors and exteriors.
Odourless and dilutable in water it enhances the grain of the wood using natural and bright colours for deep penetration of the wood.
Water repellent and breathable it protects the wood from atmospheric agents. Added UV filters impart light-stability and special additives protect the wood against harmful biological agents. Application of two or three coats is recommended. Recommendations for application:
The colours of Naturaqua Holzwachs Lasur 3IN1 are brighter than the same Holzwachs Lasur 3IN1 oil-wax base.
The level of protection offered by the two products is very similar, however the water-based version needs intermediate sanding between the coats and restoration phase.

This waterbased product lightens the colour of raw wood and neutralises the effect of the two aging vehicles Holz Antix 2008 and Holz Antix 2010, returning ing the colour back to the original one.
To avoid unwanted effects, we recommend overcoating with products from our Parquet Oil Range and afterwards, if required, apply a waterbased finish.
Recommendations for application:
Apply the product on raw wood or on surfaces that were treated with Holz Antix 2008 or 2010 using synthetic brushes or sponges or, on wide areas, using a spreader.
A preliminary test is always recommended to verify the result.
Suitable also for use on oak wood.
Approx. yield: 20-30 m²/Lt.

Water based detergent to restore wood to its natural color. It removes the gray patina caused by the decomposition of lignin under the action of ultraviolet radiation.
Apply on the wet surface, leave for 5 minutes, then clean the wood with a stiff brush. Rinse with water after application. Ideal for coverings, garden furniture, fences, decking.
Massage the surface with a brush or brush until the surface is still wet. The result is immediate.
If necessary, repeat the operation.

Wax-effect finish for interior and exterior. Enhances the structure of the wood. Water repellent and breathable, it protects the wood from atmospheric agents, also thanks to UV filters. Contains additives to protect wood from harmful biological agents.
Application in two coats is recommended.
For greater resistance of the coating, apply Holz Lasur as a first coat.
Suitable for ceilings, beams, external cladding, wooden houses, pergolas, fences, etc.

Two-component one-coat oil for the finishing of all wooden surfaces both indoors and outdoors. Mix of natural oils, zero emissions, 100% solid content, to be cured at 30%. Easy to apply (manual or with single-brush), it allows to treat all surfaces both indoors and outdoors with excellent levels of protection. To be used in combination with the relatedcatalizzatore in rapporto 100:30.