Water based detergent to restore wood to its natural color. It removes the gray patina caused by the decomposition of lignin under the action of ultraviolet radiation.
Apply on the wet surface, leave for 5 minutes, then clean the wood with a stiff brush. Rinse with water after application. Ideal for coverings, garden furniture, fences, decking.
Massage the surface with a brush or brush until the surface is still wet. The result is immediate.
If necessary, repeat the operation.

Two-component one-coat oil for the finishing of all wooden surfaces both indoors and outdoors. Mix of natural oils, zero emissions, 100% solid content, to be cured at 30%. Easy to apply (manual or with single-brush), it allows to treat all surfaces both indoors and outdoors with excellent levels of protection. To be used in combination with the relatedcatalizzatore in rapporto 100:30.

It allows intensive cleaning of the wood, removing stubborn dirt and residues of previous oil-based or impregnating treatments. It is also used to degrease exotic timbers particularly rich in oils and extracts. In this case it is recommended to dilute the product with water 1: 1. Wet the substrate with plenty of water before treatment. Due to the high concentration of active ingredients, Extra Strong Wood Cleaner can alter the natural color of the wood making it darker. To restore the original color of the wood, use Exterior Wood Cleaner later.

It is a decking oil formulated on the basis of reinforced natural oils with a high penetration coefficient. Thanks to its low viscosity it penetrates deep into the wood and thanks to the high solid content it gives an effective and breathable protection without exfoliation and with a natural satin effect. Enriched with UV filters and protective additives against harmful wood agents. The product is characterized by an extreme ease of application, even if colored, and maintenance (it does not require sanding).

High solid water-based sealer, special for protecting the ends of beams, poles and other wooden structures exposed to humidity and weathering. Also suitable for sealing longitudinal cracks. It prevents the penetration of moisture into the wood, preventing the formation of mold and thus extending the life of the protective coating and of the product in general. Transparent, it has excellent resistance to UV rays. The product can be colored with Waterbased Pigments. Apply as a first product or as an intermediate in the case of traditional water or solvent-based finishing cycles. Apply as a last product in the case of oil finishing cycles, to allow this material to penetrate into the wood.

The thermo-treated wood is characterized by a very high density, which often prevents the correct adhesion of conventional finishing products. Thermowood Oil based on raw materials from renewable sources is specifically formulated to penetrate deeply and therefore be well absorbed even by difficult substrates with minimal wettability. Enriched with UV filters and protective wood additives, it creates a wear-resistant protective film, ideal for all thermo-treated outdoor wooden items, including flooring, terraces and bridges. Application in at least two coats is recommended.
1) In case of particularly compact surfaces, for the first coat Thermowood Oil can be diluted from 20% to 30% with Solvoil 06, a slow drying solvent. Proceed with the application of subsequent coats without dilution.
2) To obtain a marked decorative effect, proceed with finishing with a final coat of Decking Oil - Danish Oil.

Regenerates every type of surface, giving additional protection to the original oil finish of the product. The presence of UV filters and special additives protect the wood from harmful agents, direct sunlight and bad weather. Enhances its natural beauty with a natural satin effect.

.With low environmental impact. Almost odorless, highly transparent, it protects all types of wood.
Characterized by a rapid drying, it gives the wooden surfaces a pleasant decorative effect.
UV filters and special additives make it suitable for outdoor use. R
ecommended as a transparent finish, it can be applied on various colored products to increase the protection coefficient: Holz Lasur, Holzwachs Lasur, Teak Oil and Terrace OIl.

Catalyst for two components lacquer for exterior Exterior Wood Lack 2k.

Oil based product, ready to use, suitable for all wooden surfaces, both indoors and outdoors. It gives water repellency and maintains a pleasantly natural appearance on the surface. Also suitable for immersion. Protects from atmospheric and biological agents and enhances the natural beauty of wood. Colorless or pigmented. It does not undergo exfoliation and does not require sanding. It can be used alone as a periodic surface treatment or as a colored primer before transparent oil finishes(es. Decking Oil HD ).